Subaru Security Light Flashing Car Wont Start

I reprogrammed the key and got all the beeps and light blinks when expected.

Subaru security light flashing car wont start.

Turn the key off and wait 5 seconds. The second key now causes the security light to glow red when i insert the key in the ignition. My car won t start. In that case the car s system won t be able to read the security code off the key fob.

With the key still in the run position wait 10 minutes and the security light should blink and then go out. The security light is going to be flashing. Leave it for ten minutes like that until the security light turns solid not blinking. Only one key will start the car though whereas both worked fine before.

What can i do. The first thing you should take a look into when the anti theft system car wont start is the car battery. It could be dead or low and needs charging. Repeat these steps for a total for 3 10 minute cycles.

Blink 2015 outback i have the manuel. It could be dead or low and needs charging. Holding unlock answered by a verified subaru mechanic. Its other main purpose is to indicate that the security of your vehicle may have been compromised and the engine has been immobilized to prevent potential theft.

Insert the ignition key and turn it to the on position and then attempt to start the engine crank over the engine wont start. On some vehicles it will flash when the ignition is off and the oem security is activated.